ThinkDesign Teapot Modeling Process (2)

Array the curved surface at the bottom of the kettle body, the result is shown in the figure

Create a teapot handle with a tubular surface command and combine it with the body for Boolean operations. Combine all previously created surfaces and solids to create an entity, the body part of the pot.

A 15 mm linear surface is created downwards by means of the lower edge of the kettle, and the boundaries are all filled. The lower circle of the obtained linear surface is offset outward by 3 mm on the plane, and the linear surface is generated by the offset circle as the base of the teapot, the linear surface length is 12 mm, the angle is 5° outward, and the boundary is completely filled.

A linear surface of 25 mm long and 55° angle is formed upward by the upper side of the kettle as a lid, a 0.5 mm rounded corner is added to the lower side of the lid, and a 3 mm rounded corner is added to the upper side. Create a point on the created centerline, create a curved face with capping, add a thickness of 0.5mm to the face, and then add a 0.3mm chamfer

Use the centerline to make the tubular surface as the pillar, then draw a circle of the appropriate size at the upper end of the centerline, and use the rotating surface to make a sphere as the handle of the lid.

Previous page next page

Clawfoot Acrylic Bathtub is one kind of Acrylic Bathtub. We pack clawfoot acrylic bathtub by pallet. The advantage of acrylic bathtub are beautiful appearance, no bubbles , anti-pollution , easy to clean and maintain, professional packing design , accept OEM processing.

1. Utimate versatality in bathroom placement