How to Assemble a Chain Link Fence
Building a chain link fence is a great way to secure your yard and keep pets and children safe. It's also an effective way to define property lines and maintain a clean, professional look in your neighborhood. With the right tools and careful planning, you can install a durable chain link fence that will last for years with minimal upkeep.
Tools You'll Need:
Tape measure
Step 1: Plan and Mark the Area
Step 2: Dig Post Holes
Step 3: Set Terminal Posts
Step 4: Install Line Posts
Step 5: Attach the Rails
Step 6: Hang the Chain Link Fabric Lever Locks,Privacy Door Lever Set,Zinc Cylinderical Door Handle,Door Handle With Keyless Lock ONLEE HARDWARE CO.,LTD , https://www.onleehardware.com
Post hole digger
Mason line
Stakes
Quick-dry concrete
Levels
Pliers
Sledge hammer
Wheelbarrow
Shovel and hoe
Wire cutters
Hacksaw or pipe cutter
Crescent wrench
Fence stretcher or ratcheting power pull
Before starting, check local regulations about fence height, setbacks, and property lines. Make sure to locate any underground utilities before digging. Use chalk to mark the fence line and discuss it with your neighbors to avoid disputes. This step ensures everything goes smoothly later on.
Dig holes for your fence posts, making them three times the diameter of the post. For end posts, dig about seven inches deep, and five inches for line posts. Widen the bottom slightly and taper the top. This helps with stability and drainage. Always double-check the depth and placement before proceeding.
Pour quick-dry concrete into each terminal post hole and insert the post. Use a level to ensure the post is straight as you add the final layers of concrete. Slope the top slightly away from the post to help water drain away. Let the concrete cure for at least two days before moving on to the next step.
Once the terminal posts are set, stretch a mason line four inches below the top of the terminal posts. This line will guide the height of all line posts. Fill each hole with concrete, place the post, and adjust it to match the mason line. Level each post and let the concrete dry for two days before continuing.
Place tension bands around each terminal post, using six bands for corners and three to four for others. Install rail caps and brace bands, tightening only enough to hold them in place. Secure a post cap on each terminal post and a looped cap on each line post. Slide the rails through the caps and adjust their length as needed. Then, bolt the rails into the terminal caps and tighten the brace bands for added support.
Unroll the chain link mesh outside the fence line. Insert a tension bar into the first few links and attach it to the tension bands. Align the mesh so it overlaps the rail by two inches. Continue unrolling the fabric toward the next terminal post and insert another tension bar a few feet away. Use a fence puller to tighten the mesh until it’s taut but not over-stretched. Bolt the second tension bar to the next terminal post and remove the puller once everything is secure. This ensures the fence remains tight and stable over time.