Emergency preparation In order to prevent accidents such as fires, leaks, collapses, etc., and to obtain valuable time for dealing with emergencies, we must prepare for emergency response. Place rags and fire-fighting equipment (fire extinguishers) near the hazardous chemicals. The fire exits near the hazardous chemicals remain unblocked. 2. Method of emergency implementation A Emergency response when grease leaks If the storage container is broken, collapsed, or mishandled, etc., the operator should quickly control the spread or increase the degree, stop the work, and use the tools nearby to give control, such as blocking the crack with a rag. For the purpose of recycling as much as possible, the ground or the like is polluted or infiltrated by the cloth. For flammable light oil, if the quick-drying oil leaks, pay attention to fire prevention when it is corresponding. If there is a fire, refer to the corresponding instructions in the "Fire Emergency Correspondence Guide", which should be reinforced when the unstable storage occurs or may collapse. deal with. B When the cleaning fluid leaks The cleaning fluid flows out and the operator should quickly control the spread or increase in severity. Absorb or wipe the ball out of the rags that have been discharged as much as possible, contaminated or impregnated on the ground, etc., anywhere. For areas that cannot be absorbed or wiped, consider the filtration method or after absorption, after wiping, outside the workshop, if possible, contact the fire brigade to ensure that it is safe to enter the ground. Pay attention to fire when leaking. An emergency response when a leak causes personal injury. On-site personnel take prompt emergency treatments for the injured, such as simple dressing, water flushing, etc., and the team leader reports the accident immediately. High Resistance Alloy is used to produce resistance elementof conductive material.Requirements including High mechanical strength, good corrosion resistance and oxidation resistance. Working temperature is usually at500 ℃. Commonly used with constantan chromium iron, iron chromium aluminum, nickel chromium, nickel, resistivity rho (20 ℃) is 1 Ω was/m or so. It is not used in the conduction of current, but with its high resistance to limit or control the current in the circuit, such as motor, potentiometer, standard resistors, potentiometers, slip line resistor resistance element and resistance line, etc.; For the using of high resistance in the pressure sensor,Temperature compensator and temperature measuring resistor of resistance element to creatte reflect strain, temperature, magnetic field and parameters; High resistance alloy can also be used as heating elements in the manufacture of the resistance heating equipment, could be applied in current, voltage regulating and the winding of control components. Resistance Electrothermal Alloy Resistance Alloy,Corrosion Resistant Alloy,Resistance Electrothermal Alloy,Fecral Resistance Heating Alloys Jiangsu nickel alloy Co.,Ltd , https://www.xhalloy.com