>>> Circuit Construction Process Water and electricity are the most important aspects of modern home improvement, and many households suffer from fire, electrical leakage, and improper water handling. The accidents caused by “water downstairs†are caused by non-standard construction, so the circuit in the home improvement Renovation should pay special attention to the following points in the renovation: First all wires must be sleeved. Otherwise, if these lines are aging for a long time, they may cause leakage. If you change lines, you must dismantle walls and wooden floors.... Therefore, the first step in circuit reconstruction is to confirm that the construction process is particularly important, and it is related to the quality of the entire project. Second, all lines must be live lines. When I first started listening to workers, I didn't think it was right. Later, facts proved that my thoughts were wrong. After watching them fix the tubes and thread them, they feel that they have a lot of things. Just put the line in the tube and fix it well, and the tubes are good looking. (At the time I still wanted to do what I wanted, the duration At least one third can be reduced). They said that this is not in conformity with the construction specifications. It is a dead end that they can't go through, and they can't pull out one of them and replace it. Again, take care when connecting the wires. Do not lead them anywhere. When my home was undergoing circuit reconstruction, I didn't strictly follow the circuit serial connection socket of the distribution box. I used the bathroom's socket line to pass through the wall directly to the living room, or took the bedroom's socket to the bathroom. Later I didn't know that the line of these outlets was Where did it come from? If there is anything or checking the circuit, it will only be able to switch off the power. It is also important that sockets and lighting are not messed up. I heard that there was a well-known professional company. The new socket in the master bedroom was cited by the worker from the lights of the main guard. Later, it was used for a trip. However, the problem could not be checked. Finally, the engineer discovered that the worker was operating illegally. However, at that time, the house was completely renovated and it was impossible to dismantle it. In addition, there must be tin brushing at the joints of the wires, and some workers put the wires together and wrap the insulating tapes in the boxes. In fact, the formal alignment step is that the thread's butt should be wrapped around 7 laps and a half, and then brush tin, wrapped with waterproof tape, and then wrapped with insulating tape can! Many workers are now wrapped in insulating tape. Some even do not use insulating tape, but use a waterproof tape to wrap it around. Finally, after all the circuit transformation is complete, don't forget to ask for a circuit diagram. This is a very important part. Many years later, the family wants to update the line or want to upgrade. If there is no circuit diagram, then professional people can't do it. Hydropower renovation socket home decoration lighting home decoration electrical decoration living room bathroom waterproof bedroom lamp