Tempered Glass,Chemical Toughened Glass,Custom Tempered Glass,Toughened Glass Huaian Hongrui Glass Co.,Ltd , https://www.hongruiglass.com
Centrifuge operator notes
When the centrifuge is in the pre-cooling phase, it is essential to ensure that the cover is securely closed. After the centrifugation process is complete, the rotor should be carefully placed on the designated test bench, and any remaining moisture inside the chamber must be thoroughly dried. At this point, the centrifuge lid should remain open for proper ventilation and safety. It is important to note that during the pre-cooling stage, the centrifuge cover must always be closed. Once the process is finished, the rotor should be placed on the test bench, and residual water inside the chamber should be removed. The centrifuge lid should then be left open.
Second, when pre-cooling, the centrifuge rotor can either be placed on the centrifuge platform or on the test bench. However, it must never be screwed directly onto the rotor. If the rotor is not properly secured, it could cause the cover to fly off during operation, leading to serious accidents. Always double-check the stability of the rotor before starting the machine.
Third, after tightening the screw cap, it is crucial to check the gap between the rotor and the cover using your fingers. If there is any noticeable space, you should loosen the cap and retighten it until the gap is completely eliminated. Only then should the centrifuge be started to ensure safe operation.
Fourth, during the entire centrifugation process, the operator must remain in the room and not leave the area unattended. In case of any unusual noise, vibration, or malfunction, do not turn off the power supply. Instead, press the STOP button immediately. Before starting the pre-cooling process, make sure to complete the centrifuge usage record accurately.
Fifth, always use genuine and high-quality centrifuge tubes. Avoid using counterfeit, aged, deformed, or cracked tubes, as they may break during operation, potentially damaging the equipment or causing harm.
Sixth, after completing all routine safety checks, it is acceptable to leave the centrifuge unattended during holidays or evening hours. However, always ensure that the machine is properly secured and the area is clean.
Seventh, in the event of a malfunction or unexpected issue while using the centrifuge, contact the technical support team immediately. Do not attempt to repair or adjust internal components yourself, as this may lead to further damage or safety hazards.
Always follow these guidelines to ensure a safe and efficient operation of the centrifuge. Proper maintenance and adherence to safety protocols are key to preventing accidents and prolonging the life of the equipment.
Http://news.chinawj.com.cn Submission: