Lighting Trunking System Lighting Busbar,Power Busbar,Lighting Busbar System,Lighting Busbar Trunking System Yangzhong Huaxin Power Equipment Co.,Ltd , http://www.huaxinbusbarchina.com
The flashlight should not be placed under sunlight or high temperature environment. After the flashlight is stopped, please take out the battery and store it in a cool and dry place. Do not touch the flashlight with sunlight, water, chemicals, and turbid gas for a long period of time to avoid damage to the torch protection layer.
Do not use over voltage, the voltage should not exceed 4.5V, the positive electrode of the battery is facing forward, do not set it backwards, otherwise it will burn the circuit board, pay attention to control the change of temperature of the torch, non-professionals do not open the circuit board.
If the flashlight is not used for a long period of time, the battery should be fully charged and normally charged and discharged again in about three months to avoid chemical corruption. When charging, please look for the positive and negative poles of the electrical appliances, do not overcharge and over discharge, so as not to damage the life of the battery. Note: The rechargeable battery can not run out of power, otherwise it can not be charged. When using a flashlight, check that there is no loosening at the threads, and if the threads are not tightened, they may not be bright or bright.
Note: When the flashlight is charging, the charger indicator light changes from "red" to "green". In this case, unplug the charger and stop charging. Do not reverse the polarity when charging (If you find that the light is insufficient, generally about 1/3 of the maximum brightness, please charge immediately!), Otherwise it may cause the flashlight to be scrapped (positive pole with "+" number toward the flashlight head ). At the same time, please do not exhaust the lithium battery completely. If the brightness becomes dark during use, charge the battery in time. Otherwise, the battery may be overcharged and discarded. Non-professionals do not disassemble the flashlight to prevent damage to the circuit board. Do not shine light directly on the eyes to avoid injury to the eyes.
With rated operational voltage (Ue) 500 Volt, AC
FEATURES
Independent Certificate Authority CPRI – India
Conductor Material & Ratings Copper – 25A, 32A, 40A, 63A
Rated Operational Voltage (Ue) 500 Volt, AC
Enclosure Material Aluminium
Busbar Insulation Flame Retardant PVC (Class `A`-105 Deg C)
Section Jointing Inbuilt push fit joint
Plug in Box rating Upto 16 A (with/without fuse)
Degree of Protection IP 55 / IP 54
How to maintain your flashlight?
The flashlight lamp wall should be kept clean. Never try it with a hand or a hard object. Remove the fingerprint on the lens. Use a cotton swab to remove the lens cleaner.